Stewart Pinned Products(Zhengzhou) Ltd
Tel:+86 371 6226 5807/9
Mail:info@pinnedproducts.cn
Add:Jiulong Industrial Park, Jingkai District,
Zhengzhou City, P R China
|
Needle roller selection for high speed carding linesNeedle roller performance on a high speed carding line is decided long before installation. Wire gauge, needling density and the hardness of the base tube together determine how the roller behaves at elevated rpm, and a mismatch shows up quickly as fibre damage, vibration or shortened service life. The first choice is needle density against fibre type. Fine denier fibre needs a higher needling density with a smaller wire diameter so that fibres are opened without being cut, while coarse or recycled fibre tolerates a heavier wire and lower density. Increasing density beyond the point where fibre can penetrate freely only adds drag and heat. Balance and true running matter more as speed rises. A needle roller that is out of balance produces a vibration signature at the bearing housing which accelerates wear on both the roller and the card clothing. Check run out after mounting and re balance if the reading exceeds the manufacturer tolerance. Maintenance practice should include periodic inspection of needle tips under magnification: bent or hooked tips pull fibre instead of opening it, and replacing the roller at that point is cheaper than the quality loss that follows. Stuart Pinned Products supplies needle roller and pinned products for carding and nonwoven lines, with selection guidance based on fibre type and line speed. Image: needle roller mounted on a high speed carding line (photo: product image from this site) |